RE: Process control before simulation starts

Bishnupriya,

Fine. I guessed that was what you meant. I think the semantics are clear.

John A

From:
Bishnupriya Bhattacharya <bpriya@cadence.com>
To:
"john.aynsley@doulos.com" <john.aynsley@doulos.com>, Stuart Swan
<stuart@cadence.com>
Cc:
"systemc-p1666-technical@eda.org" <systemc-p1666-technical@eda.org>
Date:
21/07/2010 06:27
Subject:
RE: Process control before simulation starts

John,
 
Hmm.........it does seem quite cryptic.
 
I think I meant that no special rules are necessary to determine the
behavior before simulation start. Whatever other rules are specified for
enable and resume will apply or will be adequate to determine the behavior
in this case also.
 
Let me know if something is not adding up here.
 
Thanks,
-Bishnupriya

From: john.aynsley@doulos.com [mailto:john.aynsley@doulos.com]
Sent: Tuesday, July 20, 2010 6:23 PM
To: Bishnupriya Bhattacharya; Stuart Swan
Cc: systemc-p1666-technical@eda.org
Subject: Process control before simulation starts

Bishnupriya, Stuart,

In the Process Control spec you say:

"Resuming a process before simulation has started shall not be a special
case"
"Enabling a process before simulation has started shall not be a special
case"

Please spell out what you mean.

Thanks,

John A

-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.