Add Path Analysis Set dialog box

Use this dialog box to specify a custom path analysis set.

Note: The Analysis menu is available only in Maximum or Minimum Delay Analysis view.

To open the Add Path Analysis Set dialog box (shown below) from the SmartTime Timing Analyzer, choose Actions > Analysis > Path Set.

Add Path Analysis Set Dialog Box

Name

Enables you to enter the name of your path set.

Trace from

Specifies if you want to trace connected pins from Source to sink or from Sink to source. By default, the pins are traced Source to Sink.

Source Pins

Displays list of available and valid pins. You can select multiple pins.

Filter source pins

Enables you to specify the source Pin Type and the Filter. The default pin type is Registers by pin name. You can specify any string value for the Filter. If you change the pin type, the Source Pins shows the updated list of available source pins.

Sink Pins

Displays list of available and valid pins. You can select multiple pins.

Filter sink pins

Enables you to specify the sink Pin Type and the Filter. The default pin type is Registers (by pin). You can specify any string value for the Filter. If you change the pin type, the Sink Pins shows the updated list of available sink pins.