Answers Database
Prolink may hang after blank check on some pcs
Record #215
Product Family: Software
Product Line: FPGA Core
Product Part: prolink
Problem Title:
Prolink may hang after blank check on some pcs
Problem Description:
On some PCs the HW-120 programmer (with Prolink) may hang after the blank
check stage of the programming command.
Solution 1:
CAUSE:
The programmer is unable to communicate with the host PC using
the default protocol.
SOLUTION:
Change stop bits from 2 to 1
Solution 2:
CAUSE:
The problem is that the current version of the EPLD programmer runs at
19.2Kbaud by default, and not all PC serial cards are able to support this
transfer rate.
SOLUTION:
Verify that the PC serial card supports 19.2Kbaud. If it doesn't, try the
programmer on another PC.
End of Record #215 - Last Modified: 12/19/95 08:58 |
