Answers Database
Cable - Can I use the Parallel Cable III (JTAG Cable) to configure an FPGA?
Record #3630
Problem Title:
Cable - Can I use the Parallel Cable III (JTAG Cable) to configure an FPGA?
Problem Description:
Urgency: Standard
General Description: Can the Parallel Cable III (JTAG Cable Model DLC5)
be used to configure an FPGA?
Solution 1:
The JTAG/Parallel cable can be used to configure an FPGA when
using Hardware Debugger 1.4.12 or later.
From the pod on the cable connect all pins in the FPGA section
on the label (VCC, GND, CCLK, D/P, DIN, PROG) to the
corresponding pins on the FPGA.
You will have to supply VCC and a common GND to the cable.
End of Record #3630 - Last Modified: 12/20/99 15:40 |
