RFC 2763






Network Working Group                                           N. Shen
Request for Comments: 2763                                Siara Systems
Category: Informational                                         H. Smit
                                                          Cisco Systems
                                                          February 2000


                  Dynamic Hostname Exchange Mechanism
                               for IS-IS

Status of this Memo

   This memo provides information for the Internet community.  It does
   not specify an Internet standard of any kind.  Distribution of this
   memo is unlimited.

Copyright Notice

   Copyright (C) The Internet Society (2000).  All Rights Reserved.

Abstract

   Currently, there does not exist a simple and dynamic mechanism for
   routers running IS-IS to learn about symbolic hostnames. This
   document defines a new TLV which allows the IS-IS routers to flood
   their name to system ID mapping information across the IS-IS network.

1. Introduction

   IS-IS uses a 1-8 byte system ID (normally 6 bytes) to represent a
   node in the network.  For management and operation reasons, network
   operators need to check the status of IS-IS adjacencies, entries in
   the routing table and the content of the IS-IS link state database.
   It is obvious that, when looking at diagnostics information,
   hexadecimal representations of systemIDs and LSP identifiers are less
   clear than symbolic names.

   One way to overcome this problem is to define a name-to-systemID
   mapping on a router. This mapping can be used bidirectionally. E.g.,
   to find symbolic names for systemIDs, and to find systemIDs for
   symbolic names. One way to build this table of mappings is by static
   definitions. Among network administrators who use IS-IS as their IGP
   it is current practice to define such static mappings.

   Thus every router has to maintain a table with mappings between
   router names and systemIDs. These tables need to contain all names
   and systemIDs of all routers in the network.




Shen & Smit                  Informational                      [Page 1]

RFC 2763                    Dynamic Hostname               February 2000


   There are several ways one could build such a table. One is via
   static configurations. Another scheme that could be implemented is
   via DNS lookups. In this document we propose a third solution. We
   hope the proposed solution is easier and more manageable than static
   mapping or DNS schemes.

2. Possible solutions

   The obvious drawback of static configuration of mappings is the issue
   of scalability and maintainability. The network operators have to
   maintain the name tables. They have to maintain an entry in the table
   for every router in the network. They have to maintain this table on
   each router in the network. The effort to create and maintain these
   static tables grows with the total number of routers on the network.
   Changing the name or systemID of one router, or adding one new router
   introduced will affect the configurations of all the other routers on
   the network. This will make it very likely that those static tables
   are outdated.

   Having one table that can be updated in a centralized place would be
   helpful. One could imagine using the DNS system for this. A drawback
   is that during the time of network problems, the response time of DNS
   services might not be satisfactory or the DNS services might not even
   be available. Another possible drawback might be the added complexity
   of DNS. Also, some DNS implementations might not support A and PTR
   records for CLNS NSAPs.

   A third way to build dynamic mappings would be to use the transport
   mechanism of the routing protocol itself to advertise symbolic names
   in IS-IS link-state PDU. This document defines a new TLV which allows
   the IS-IS routers to include the name to systemID mapping information
   in their LSPs. This will allow simple and reliable transport of name
   mapping information across the IS-IS network.

3. The Dynamic Hostname TLV

   The Dynamic hostname TLV is defined here as TLV type 137.

         LENGTH - total length of the value field.

         VALUE - a string of 1 to 255 bytes.

   The Dynamic hostname TLV is optional. This TLV may be present in any
   fragment of a non-pseudo node LSP. The value field identifies the
   symbolic name of the router originating the LSP. This symbolic name
   can be the FQDN for the router, it can be a subset of the FQDN or any
   string operators want to use for the router. The use of FQDN or a




Shen & Smit                  Informational                      [Page 2]

RFC 2763                    Dynamic Hostname               February 2000


   subset of it is strongly recommended. The content of this value is a
   domain name, see RFC 2181. The string is not null-terminated. The
   systemID of this router can be derived from the LSP identifier.

   If this TLV is present in a pseudo node LSP, then it should not be
   interpreted as the DNS hostname of the router.

4. Implementation

   The Dynamic Hostname TLV is optional. When originating an LSP, a
   router may decide to include this TLV in its LSP. Upon receipt of an
   LSP with the dynamic hostname TLV, a router may decide to ignore this
   TLV, or to install the symbolic name and systemID in its hostname
   mapping table.

   A router may also optionally insert this TLV in it's pseudo node LSP
   for the association of a symbolic name to a local LAN.

5. Security Considerations

   This document raises no new security issues for IS-IS. However, it is
   encouraged to use authentications for IS-IS routing protocol.  The
   authentication mechanism for IS-IS protocol is specified in [1] and
   it is being enhanced within IETF in [2].

6. Acknowledgments

   The authors would like to thank Enke Chen and Yakov Rekhter for their
   comments on this work.

7. References

   [1] ISO, "Intermediate system to Intermediate system routing
       information exchange protocol for use in conjunction with the
       Protocol for providing the Connectionless-mode Network Service
       (ISO 8473)," ISO/IEC 10589:1992.

   [2] Li, T., "IS-IS HMAC-MD5 Authentication", Work in Progress.













Shen & Smit                  Informational                      [Page 3]

RFC 2763                    Dynamic Hostname               February 2000


8. Authors' Addresses

   Naiming Shen
   Siara Systems, Inc.
   1195 Borregas Avenue
   Sunnyvale, CA, 94089

   EMail: naiming@siara.com


   Henk Smit
   Cisco Systems, Inc.
   170 Tasman Drive
   San Jose, CA, 95134

   EMail: hsmit@cisco.com



































Shen & Smit                  Informational                      [Page 4]

RFC 2763                    Dynamic Hostname               February 2000


9. Full Copyright Statement

   Copyright (C) The Internet Society (2000).  All Rights Reserved.

   This document and translations of it may be copied and furnished to
   others, and derivative works that comment on or otherwise explain it
   or assist in its implementation may be prepared, copied, published
   and distributed, in whole or in part, without restriction of any
   kind, provided that the above copyright notice and this paragraph are
   included on all such copies and derivative works.  However, this
   document itself may not be modified in any way, such as by removing
   the copyright notice or references to the Internet Society or other
   Internet organizations, except as needed for the purpose of
   developing Internet standards in which case the procedures for
   copyrights defined in the Internet Standards process must be
   followed, or as required to translate it into languages other than
   English.

   The limited permissions granted above are perpetual and will not be
   revoked by the Internet Society or its successors or assigns.

   This document and the information contained herein is provided on an
   "AS IS" basis and THE INTERNET SOCIETY AND THE INTERNET ENGINEERING
   TASK FORCE DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING
   BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION
   HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF
   MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

Acknowledgement

   Funding for the RFC Editor function is currently provided by the
   Internet Society.



















Shen & Smit                  Informational                      [Page 5]