Answers Database


Xchecker Cable: Can the Xchecker cable be used to program via JTAG Programming? Where is TDO?


Record #1095

Product Family: Hardware

Product Line: Other

Product Part: XChecker Cable

Problem Title:

Xchecker Cable:	Can the Xchecker cable be used to program via JTAG Programming?  Where is
TDO?



Problem Description:
General Description:

Can the Xchecker serial cable by used to program an XC9500
CPLD, instead of using the EZTAG cable? Can the xchecker read
TDO values if it is powered by a 3.3V supply?


Solution 1:

There are two ways of using the xcheker cable in a 3.3V
environment.

1. Use the xchecker 3.3V adapter, or

2. Use a 5V supply to power the xchecker and a 3.3V system
supply and connect the GROUNDS.



Solution 2:

The Xchecker cable may be used to program an XC9500 CPLD.

The connections needed to program a 9500 device are the
following JTAG pins: TDI, TMS, TCK, and TDO.

The Xchecker cable has 3 of these 4 pins -- TDI, TMS, and TCK.
There is no connector labeled TDO on the Xchecker cable. Use
the RD connector instead.

As the Xchecker cable is a serial cable, the programming will
be slower than that of the EZTAG cable, which is a parallel cable.



Solution 3:


  0 Vcc to board Vcc
  0 Gnd to board Ground
  0 TDI to TDI
  0 TMS to TMS
  0 RD to TDO
  0 TCK to TCK





End of Record #1095 - Last Modified: 06/08/99 08:00

For the latest news, design tips, and patch information on the Xilinx design environment, check out the Technical Tips!