Use the wire command to draw wires between various objects and provide connectivity on the schematic. This is often a tedious and time-consuming task. To automate the task of wiring the components on a schematic page, use the Auto-Wire feature in Capture.
This feature allows you to wire two or more points on the schematic page. It also allows you to wire multiple points on your schematic to a bus.
When wiring the parts on a page, you wire two (or more) pins on different parts or the same part (for shorting). You can create a net between two (or more) wires and you can also create a net between any number of pins and wires on a page.
In this Section: