Re: MOS11 noise implementation in Verilog-A

Sri -
It's not clear that $abstime should return 0 in an AC analysis.
In some cases, we have users run a transient to a certain time,
then they want to perform a small-signal analysis of the circuit
at that operating point. In that case, an independent sinusoidal
source should be set to the value at the time where the transient
was stopped.

-Geoffrey

Srikanth Chandrasekaran wrote:
>
> Just a side note on $freq. $freq i am assuming would be synonymous to
> $abstime in transient. I am assuming $abstime would return 0 in a AC
> analysis. What would be good to have a generic function - something like
> $domainval or $xval or something like that which would return either the
> time/freq/voltage depending on the analysis being performed.
>
Received on Thu May 20 07:52:30 2004