Internet Draft
Network Working Group                                   Mike O'Dell
Internet Draft                                          Jed Kaplan
Expiration Date: November 1999				UUNET Technologies, Inc.

							John Hayes
							Ted Schroeder
							Alteon WebSystems, Inc.
							
							P.J. Singh
							Packet Engines, Inc.

							Daemon Morrell
							Juniper Networks, Inc.

							Jennifer Hsu
						


	          Extended Ethernet Frame Size Support 

		    draft-kaplan-isis-ext-eth-01.txt


1. Status of this Memo

	This document is an Internet-Draft and is in full conformance with 
	all provisions of Section 10 of RFC2026.

	Internet-Drafts are working documents of the Internet Engineering
	Task Force (IETF), its areas, and its working groups. Note that
	other groups may also distribute working documents as Internet-
	Drafts.

	Internet-Drafts are draft documents valid for a maximum of six months 
	and may be updated, replaced, or obsoleted by other documents at any
	time. It is inappropriate to use Internet-Drafts as reference
	material or to cite them other than as "work in progress."

	The list of current Internet-Drafts can be accessed at 
	http://www.ietf.org/ietf/lid-abstracts.txt

	The list of Internet-Draft Shadow Directories can be accessed at
	http://www.ietf.org/shadow.html


2. Abstract

	This document presents an extension to current Ethernet Frame 
	standards to support payloads greater than 1500 Bytes for Ethernet_II
	and 802.3 frames. This is useful for Gigabit Ethernet technology, 
        providing a means to carry large MTU packets without fragmentation 
        over a high-speed broadcast network.

3. Overview

	There are two fundamental frame types defined for Ethernet:
	Ethernet II [ETH] [RFC894] and 802.3 [IEEE802.3]. 802.3 headers
	may be followed by a Logical Link Control header,
	802.2 [IEEE802.2]. Both types of encapsulations can co-exist on
	the same media at the same time. Encodings for Ethernet II and 802.3
	frames evolved such that, as long as payloads were less than 1500
	bytes, Ethernet II frames could always be distinguished from
	IEEE 802.3 frames.

	However, when the payload is greater than 1500 bytes frames may 
        not be uniquely distinguishable as conforming to Ethernet II or 
        802.3 formats. This document extends the Ethernet frame format 
	to allow Ethernet_II or 802.3 frame payloads larger than 1500 bytes 
        to be uniquely distinguished.

4. Ethernet Frame Formats

	A. Ethernet II
		
		+----+----+------+------+-----+
		| DA | SA | Type | Data | FCS |
		+----+----+------+------+-----+
	  
		DA      Destination MAC Address (6 bytes)
		SA      Source MAC Address      (6 bytes)
		Type    Protocol Type           (2 bytes)
		Data    Protocol Data           (46 - 1500 bytes)
		FCS     Frame Checksum          (4 bytes)

	B. IEEE 802.3 and derivatives

		+----+----+------+------+-----+
		| DA | SA | Len  | Data | FCS |
		+----+----+------+------+-----+

		DA      Destination MAC Address (6 bytes)
		SA      Source MAC Address      (6 bytes)
		Len     Length of Data field    (2 bytes)
		Data    Protocol Data           (46 - 1500 bytes)
		FCS     Frame Checksum          (4 bytes)
	  
	The derivatives include LLC (802.2) and SNAP which prefix the
	data field with an LLC header.  In these instances the Len field
	then corresponds to the combined size of both the data portion
	of the frame and the LLC header.
	
	On reception, the two formats are differentiated based on the
	magnitude of the Type/Length field, as follows:

	> 1500 bytes:   value corresponds to a type field.  The frame is an
			Ethernet II frame, with type values starting
			at 1536 (600 hex).

	<= 1500 bytes:  value corresponds to a length field.  The frame is
			an IEEE 802.3 format (or derivative) with a maximum
			data length of 1500 bytes.

5. Problem with Large 802.3 Frames in the presence of Ethernet_II Frames

	Some protocols commonly used in the Internet, such as ESIS
	and ISIS which are carried as CLNS packets, have no reserved
        Ethertype.  Such packets can only use the IEEE 802.3/802.2 encoding, 
        and so are limited in length to 1500 bytes.

 	Ethernet_II frames have no length field. Protocols encapsulated in 
	Ethernet II frames, such as IP, are not limited in length to 1500 
        bytes by framing.

6. Proposed Ethernet Frame Extension

	Large 802.3 and Ethernet_II frames can be supported by the following:
	
	+  Define an Ethertype for 802.3, 0x8870, and encode large frames
	   (where the data field is greater than 1500 bytes),
	   exclusive of the Destination MAC address, Source MAC address,
           and Data length fields, within Ethernet II.

	   Large 802.3/802.2 frames would have the following fields:
 
		+----+----+------+------+------+------+------+-----+
		| DA | SA | Type | DSAP | SSAP | Ctrl | Data | FCS |
		+----+----+------+------+------+------+------+-----+
				  === 802.2 Header ===

		DA      Destination MAC Address                 (6 bytes)
		SA      Source MAC Address                      (6 bytes)
		Type    0x8870 (Ethertype)                      (2 bytes)
		DSAP    802.2 Destination Service Access Point  (1 byte)
		SSAP    802.2 Source Service Access Point       (1 byte)
		Ctrl    802.2 Control Field                     (1 byte)
		Data    Protocol Data                           ( > 46 bytes)
		FCS     Frame Checksum                          (4 bytes)
	  
	+  Allow Ethernet II frames to have payloads greater than 1500 bytes.

	There is no loss of information from 802.3/802.2 frames. Although 
        the 802.3 length field is missing, the frame length is known by 
        virtue of the frame being accepted by the network interface.

	In this manner, all Ethernet II frames, including large 802.3 
 	packets, can be longer than 1500 bytes, yet are uniquely identified.


7. References

[ETH] "The Ethernet - A Local Area Network", version 1.0, Digital
Equipment Corporation, September 1980, and "The Ethernet, A Local
Area Network" Data Link Layer and Physical Layer Specifications",
Digital, Intel, and Xerox, November, 1982.

[RFC894] IETF RFC 894

[IEEE802.3] IEEE Std 802.3

[IEEE802] IEEE Std 802

[IEEE802.3Z] IEEE Std 802.3z

[EXT.FRAME] "Use of Extended Frame Sizes in Ethernet Networks", draft
2.1, Alteon Networks, Inc.


8. Author's Addresses

Mike O'Dell
UUNET an MCI WorldCom Company
3060 WIllaims Drive
Fairfax, Va. 22031-4648
703-206-5890
email: mo@uu.net

Jed Kaplan
UUNET an MCI WorldCom Company
3060 WIllaims Drive
Fairfax, Va. 22031-4648
914-701-5309
email: jkaplan@uu.net

John Hayes
Alteon WebSystems, Inc.
50 Great Oaks Blvd.
San Jose, CA 95119
408-360-5507
email: hayes@alteon.com

Ted Schroeder
Alteon WebSystems, Inc.
50 Great Oaks Blvd.
San Jose, CA 95119
408-360-5500
email: ted@alteon.com

P.J. Singh
Packet Engines, Inc.
11707 East Sprague #101
Spokane WA  99206
509-777-7000
email: pjsingh@packetengines.com

Daemon Morrell
Juniper Networks, Inc.
12343-D Sunrise Valley Drive
Reston, VA 20191
email: dmorrell@juniper.net

Jennifer Hsu
jhsu@mur.com