The Configuration Problem Solver
The Mode Pins are set incorrectly.
To configure in the Slave Serial Mode the Mode Pins <M2:M1:M0> must be <111>. While these pins use the LVTTL standard threshold values make sure that these pins show a good strong logic `1' (~3 Volts). Measure the MODE pin at the actual FPGA package to insure there aren't any connection errors on the board. If this pin was left unconnected add an external pullup resistor. Although Xilinx FPGAs have an internal pullup resistor on the MODE pin, the strength of this pullup is not tested. |
HISTORY |
Family: XC4000X |
Mode: Slave Serial |
DONE: LOW |
INIT: HIGH |
LDC: LOW |
DOUT: NO |