|
|
|
|
|
|
Xilinx Answer #4056 : SPROMS: XC1700E/EL are the replacements for the XC1700D/L (up to the 17256D/L commericial and industrial grades)
Xilinx Answer #3779 : SPROMs (XC1700): How to program reset polarity on Xilinx SPROMs
Xilinx Answer #2658 : ** PROMS: Can you use a 1736A as a master to program a 1736D part?
Xilinx Answer #2571 : PROMs: What is the unprogrammed/default state of each byte address in an XC1700 PROM?
Xilinx Answer #2108 : HW-130, XC1700/D/L: Device FAILED Low Vcc or Low Voltage Verify
Xilinx Answer #1538 : PROMs: XC1736A Reset Polarity is not programmable
Xilinx Answer #1420 : SPROMS: Can the VPP/VCC pin be tied through a resistor to +5V?
Xilinx Answer #1260 : **Obsolete Solution**: Programmers: Data I/O: These programmers have been re-qualified to program Xilinx XC1700 serial PROMs
Xilinx Answer #1179 : SPROMS: Checksums: What are the PROM file and programmer checksums?
Xilinx Answer #1122 : **Obsolete Solution**: SPROMS: 1736: The 1736 device is not available as an L (low power) part.
Xilinx Answer #1029 : Programmers: HW-130: ERROR - Reset not programmed.
Xilinx Answer #930 : Programmers: Data I/O: Checksums on Data I/O programmers may not match when doing a "load" and doing a "read"
Xilinx Answer #465 : SPROMS: Configuration: 8-pin sockets w/built-in capacitors can cause multi-prom config problems
Xilinx Answer #138 : PROMS: How to program a 'D' type prom from a different type master prom with a HW-112
Xilinx Answer #136 : PROMS: AT&T flash serial proms cannot FAST configure an XC4000 device