FPGA Configuration: Top Solutions

Virtex Configuration Solutions

• Answer 5666: Virtex Configuration: Configuring Multiple Virtex Devices in SelectMAP mode.
• Answer 5865: Virtex Configuration: Done goes High, but device does not startup.
• Answer 5381: Virtex Configuration: Issues on configuring virtex and 4000X devices in daisy chain.
• Answer 5368: Virtex Configuration: what valid configuration speeds are available for virtex?
• Answer 5108: Virtex Configuration: What is the status of user I/O during configuration?
• Answer 6484: Virtex Configuration: Can CRC be disabled.

Most Requested Solutions

• Solution 1469: FPGA Configuration: XChecker - Stand alone `Error 264: DONE signal did not go high.'
• Solution 1984: FPGA Configuration: Address Pins A18 - A21 are optional for XC4000EX only.
• Solution 117: FPGA Configuration: Preparing a bitstream for Peripheral Mode copnfiguration.
• Solution 102: FPGA Configuration: DONE doesn't go high, general configuration debugging hints.
• Solution 740: FPGA Configuration: Asynch Peripheral Mode - DONE goes high, outputs not active.
• Solution 1941: FPGA Configuration: For Peripheral configuration which is the MSB D7 or D0?
• Solution 3090: FPGA Configuration: Run times for configuration rates and CPLD programming.
• Solution 492: FPGA Configuration: Minimum pulse width for PROG to reconfigure an FPGA.
• Solution 760: FPGA Configuration: XC4000E won't configure in socket designed for XC4000?